grrr_me_scary
Active member
I have a Torpedo Studio and I wanted to check with this forum to see if there would be any issues setting up my output this way.
I have two 8 ohm Mesa cabs.
I have a Mesa Mark IV that has 4 ohm outputs.
The Torpedo Studio does not have two speaker "thru" options but I want to use both cabs so it sounds like I can use them in a parallel setting.
Please confirm:
The speaker cable would come out of my 4 ohm output from the amp to the Studio speaker input set at 4 ohms then I would use the "thru" option with a speaker cable to cab 1 input and parallel out to cab 2.
**************************************************************************************************************************
Also, I wish the Studio had a stereo input/output option since I use stereo power amps as well and I set the cabs at different volumes since the have different types of speakers in each one of them.
It would seem like I need a second device to use the stereo power amps in stereo.
I have two 8 ohm Mesa cabs.
I have a Mesa Mark IV that has 4 ohm outputs.
The Torpedo Studio does not have two speaker "thru" options but I want to use both cabs so it sounds like I can use them in a parallel setting.
Please confirm:
The speaker cable would come out of my 4 ohm output from the amp to the Studio speaker input set at 4 ohms then I would use the "thru" option with a speaker cable to cab 1 input and parallel out to cab 2.
**************************************************************************************************************************
Also, I wish the Studio had a stereo input/output option since I use stereo power amps as well and I set the cabs at different volumes since the have different types of speakers in each one of them.
It would seem like I need a second device to use the stereo power amps in stereo.