Switch to full style
Guillaume Pille from Two Notes is here on board to answer all your questions about their amp simulators!
Post a reply

What is the proper way to plug/unplug cab?

Thu, Jun 25, 2020 3:10am

For instance im using a cab, with attenuation set to MID. Then I need to switch to "Silent mode" - headphones only. Should I turn everything off (power off) before unplugging cab? Or is it ok to only put amp to Standby?

Another question there is not "power button" on Captor X - so if I would like to turn it off and use just attenuation for a while, should I pull off power supply cord? Or how?

Re: What is the proper way to plug/unplug cab?

Thu, Jun 25, 2020 5:32am

When you say you are using a cab with attenuation set to MID, what are you specifically talking about?

Re: What is the proper way to plug/unplug cab?

Thu, Jun 25, 2020 5:45am

Using this toggle set in between FULL and LOW.
Attachments
Screenshot 2020-06-25 at 12.43.14.png

Re: What is the proper way to plug/unplug cab?

Fri, Jun 26, 2020 7:59am

As long as the amp is on standby, you can plug and unplug the speaker and Captor X without problem.

To power off the Captor X, simply unplug the power supply, like you would on any pedal :)

Re: What is the proper way to plug/unplug cab?

Fri, Jun 26, 2020 8:12am

Basstyra wrote:As long as the amp is on standby, you can plug and unplug the speaker and Captor X without problem.

To power off the Captor X, simply unplug the power supply, like you would on any pedal :)


Awesome! Thank you.
Post a reply