Good day everyone! New here and have a couple of questions? There was recent post about re-amping with the CABM that may answer half my questions later, but here it goes: I am going to be tracking with an Audient ID22, so I want to run vocals out (re-amp) to the CAB M. I understand about unbalanced line signal out, and balanced line back in, BUT with the pre-amp feature, reverb, eq, power amp, cabs, mics, and all the other goodies in the CAB M, has anyone tried this yet? Sure I can use plug ins or outboard gear, but I figured since I was going to re-amp the bass and guitar through it anyway, why not just re-amp the vocals through the CAB M too? One other use I want to try is usuing the CAB M as sub-kick Mic for recording my bass drum? I will be using 2 mics so I can wire my other mic out of phase to the board, and keep the mic into the CAB M in phase. I understand that this is not actually what this pedal is designed for, but I like to think outside of the box sometimes, so it may end up being my all around go too pedal if I can get good results. So, how about it ladies and gentlemen? Is it doable, or should I just plan on setting up my outboard gear and using some plug ins?
Thanks
Johnny Starr
Thanks
Johnny Starr