NewReligion
Active member
Part 1 Modding a Friedman PT20 for more gain and adding clipper selection on a on/off/on switch etc...
EDIT;;;
EDIT;;;
V2a":2kmst6x5 said:Personally, I wouldn't make a 220k series R switchable unless you make it foot switchable (for boost). Other than that, it's essentially the same as turning up the master a notch.
CrazyNutz":1hq7ozvd said:Change that first 68k/68k voltage divider (they are mounted directly to V1) to 68k/100k
That will get you a little more gain, and sound better IMHO.
I have that on a switch in my ultimate Friedman clone, and it always stays on 68k/100k
NewReligion":l9ygjcg5 said:CrazyNutz":l9ygjcg5 said:Change that first 68k/68k voltage divider (they are mounted directly to V1) to 68k/100k
That will get you a little more gain, and sound better IMHO.
I have that on a switch in my ultimate Friedman clone, and it always stays on 68k/100k
Cool, thanks. I will definitely check that out!
Here is where I am at this point with all analog. I worked it out for more clarity between notes but retaining the sustain.
CrazyNutz":3prnyz3k said:NewReligion":3prnyz3k said:CrazyNutz":3prnyz3k said:Change that first 68k/68k voltage divider (they are mounted directly to V1) to 68k/100k
That will get you a little more gain, and sound better IMHO.
I have that on a switch in my ultimate Friedman clone, and it always stays on 68k/100k
Cool, thanks. I will definitely check that out!
Here is where I am at this point with all analog. I worked it out for more clarity between notes but retaining the sustain.
Now that one sound good!