Marshall VS265 OD1 to OD2 Issue

Templeisland

New member
Hello
I have an issue with this VS265.
The foot switch is new but not able to switch between OD1 and OD2.
The repair shop charges 95.00 per hour which is WAY too much..
Has anyone had or has this issue and how did you repair it... I did read here that the input from the foot switch on the board might need to be re soldered, but the joints look good.
I could re flow and see if this fixes the issue... but in the meantime looking for any other ideas..

Thanks and much appreciated!

Bob
 
Back
Top