CharlieFoxtrot
New member
Up until this last week, I have been using my Torpedo C.A.B. with my amp head and a Weber Mini Mass load box, using the amps own power section for my tone shaping. A few days ago I got a Frenzel FM-DP1 pre amp so I have begun to use the power amp modeling part of the C.A.B. After reading a few other posts about power amp settings on the C.A.B. and my own experimentation I have a question. Would it be fair to say a good starting setting for the power amp section would be presence at 100, depth at 0 and volume at 10dB?
EDIT: I'm trying to find a neutral starting place with the power amp configuration. Presence at 100 and Depth at 0 sound as neutral as possible to me, but I'm not sure if that is true from a design standpoint?
Using my pedal board, a preamp with a gain, master, and output trim pot, as well as the volume setting on the power amp section on the C.A.B., there is a lot of places to adjust the signal level with various results. I'm trying to dial in a baseline tone/level between the Frenzel pre-amp and the C.A.B. power amp section, and I'm not sure if I am starting in the right place with the config on the C.A.B.?
EDIT: I'm trying to find a neutral starting place with the power amp configuration. Presence at 100 and Depth at 0 sound as neutral as possible to me, but I'm not sure if that is true from a design standpoint?
Using my pedal board, a preamp with a gain, master, and output trim pot, as well as the volume setting on the power amp section on the C.A.B., there is a lot of places to adjust the signal level with various results. I'm trying to dial in a baseline tone/level between the Frenzel pre-amp and the C.A.B. power amp section, and I'm not sure if I am starting in the right place with the config on the C.A.B.?