Short Tom Anderson HN3 -> Vox Tonelab clip

  • Thread starter Thread starter Variable
  • Start date Start date
Variable

Variable

Active member
Just dropped an Anderson HN3 in the bridge of my blue Legacy. I think there was a thread about Tom Anderson pickups recently, so I figured I'd do a clip. The previous pickup in this guitar was a Duncan JB. It sounded good, but was too thin for my taste (same reason I pulled it out of my ASAT as well).


So far this is the hottest pickup I've ever owned, and so far it's a keeper :D






Oh, and apologies for the massive hum at the beginning, I'm picking up a lot of EMI from my computer apparently...
 
:|::QBB:
Megadeth7684":836a1 said:
Too much gain!
Click to expand...

Coming from the guy whose favorite amp is a 5150?!

I didn't spend any time adjusting that patch, it was set for a MUCH lower output pickup...
 
Ok, here's a clip I did with about a third less gain on that patch.


 
:|::QBB:
Variable":68ce5 said:
:|::QBB:

Coming from the guy whose favorite amp is a 5150?!

I didn't spend any time adjusting that patch, it was set for a MUCH lower output pickup...
Click to expand...

Haha, my favorite amp has nothing to do with your clip. I run the gain on 3 on my 5150 with a boost.
 
:|::QBB:
Variable":1f250 said:
Ok, here's a clip I did with about a third less gain on that patch.


Click to expand...

Sounds better, but it still sounds pretty crappy IMO. Typical modeler tone.
 
:|::QBB:
Megadeth7684":2a597 said:
:|::QBB:

Sounds better, but it still sounds pretty crappy IMO. Typical modeler tone.
Click to expand...

Looks like someone's feeling especially opinionated today :gethim:
 
You must log in or register to reply here.
Back
Top