simon_d

Many thanks Ross, exactly what I wanted to know.

Hi Simon, Thanks for getting back to me. I have just sent a message to our technical team and will loop back with you regarding this...

Thanks for the info Ross. There is only one setting on the original Captor, the -20db speaker out jack. So is that output achieved with...

What is the consequence, theoretically speaking, of the amp having the captor load and then a cab load added to it when using the...

Hi Ross. Mainly for attenuation, but also into a DAW for recording. On my JVM I was experiencing odd ghost-like notes under some notes...

Thanks for the info Ross, that's exactly what I wanted to know! I have a Captor and wanted to know if the Captor X was improved on load...

Hi. Does the Captor X and Captor have the same impedance curve? Is the reactive hardware identical in both?

Right. They might be both clones of the Rane in that case (though they use xlrs mostly and a mix/split button on each channel). Can't...

Not sure what the LD Systems is, but that Behringer is very similar in function to the classic Rane SM26 I mentioned above.

Found two mixer/splitters. Behringer ULTRALINK PRO MX882 V2, which looks like a clone of LD Systems LDMS828. I think either of these...

https://reverb.com/item/47544184-rane-mx6s

Yes exactly. The Marshall loop isn't the best, but I'm upgrading it with a board from Headfirst. I've actually just set the rig up in...

I have a couple of heads, but I'm currently using a JCM800 2203 reissue (but I'm planning to upgrade the loop board in it). FX is mostly...

It´s entirely fine to split a buffered line level signal passively via a cable or jack box, but the pros often did it with a Rane SM26...

Thanks for the info Dave. If I go passive for the time being I'm thinking I can build a patch bay for the rear. Then again, could I...