BE100 problem

  • Thread starter Thread starter Jon BCN
  • Start date Start date
J

Jon BCN

Active member
So I engaged my BE100 and I started to change between the clean channel, the BE channel and the HBE channel. But oddly, nothing changed and I had exactly the same gain in all three. It's like there's only one channel which can be regulated by the gain knob.

Then I took notice that the amp smelled like something has been fried. I guess it's probably a tube?

What should I do now?
 
Try swapping out some different tubes to see if that fixes the problem? I had a cold solder joint in an amp once, but other than that the all my amp problems have always been tube related.
 
Back
Top