Dead footswitch - Please Help

  • Thread starter Thread starter KV242
  • Start date Start date
K

KV242

New member
I won't go into details on the how, but something stupid happened that rendered the channel switch dead (the footswitch got plugged into a speaker output of my Tweaker 40 :confused: ). Fortunately no damage to the amp occurred, but the channel switch is rendered dead (Effects switch seems unaffected). From what I can tell and what I'd assume, the LED is toast and needs replacement. Assuming this is the problem, any idea of the part# of the LED so that I can get a replacement?

Bruce, any suggestions, recommendations, advice?
Thanks!
 
I would guess the LED is bad, also. The part is nothing special. Any "garden variety" (Radio Shack?) will work fine. Just need to get the polarity right. If you inadvertently installed the LED backwards, it won't be damaged. Just reverse it and you should be fine.
 
Thanks Bruce, appreciate the reply! Will grab an LED and swap it out.
 
You must log in or register to reply here.
Back
Top