Does anyone make a zero loss effects loop with 1 1/4 spaced jacks?

[screamindemon]

As stated amp has passive loop now with 1 1/4 spaced jacks and would like to add a good solid state loop. Looking for opinions.
Thanks

 

[Arch Stanton]

Check into the MetroAmp zero loss loop.

It might be 1-1/2" center-to-center on the jacks though..

 

[RedPlated]

It’s 1 1/2”. If you want to use it in 1 1/4” jacks you need to lift one jack and run leads between jack and board so you can move it inward and reduce the width.

Or, you can open each hole 1/8” towards each other. The loop jack washers are large enough to cover the larger holes.

 

[screamindemon]

It’s 1 1/2”. If you want to use it in 1 1/4” jacks you need to lift one jack and run leads between jack and board so you can move it inward and reduce the width.

Or, you can open each hole 1/8” towards each other. The loop jack washers are large enough to cover the larger holes.

I was thinking about the second option you mentioned.