Egnater M4 Randall RT2/50 TC G system

[Drew Wright]

Hey everyone.

I'm new to this site and I just ordered an Egnater M4 and a Randall RT2/50. I'm curious if anyone is familiar with using a TC Electroic G system to controll this setup via midi? ie: switching the M4 Modular channels and from the 6L6's and EL34's in the RT2/50.

Thanks
Drew

 

[muudrock]

I don't have a G system, but I know it can controll the Egnater/Randall setup. I'm sure a few of the guys with this gear will chime in.
Welcome to the wonderful world of Egnater!

 

[Audioholic]

I use the G-system with pretty much the exact setup, except I don't use the Gsystem to switch midi, just use randall's 4 button footswitch and run the power amp in stereo so no need to switch channells. However I do believe its possible, just have to run the midi to either the power amp and thru to the pre amp or the other way around, and program the power amp to follow the module channels that you want to trigger whatever side (so power amp will follow however you want when you switch to a different module channel) I believe that is the way to get the power amp switching correctly and programmed with the right module you want.

 

[stephen sawall]

C l Rig

 

[again with this]

viewtopic.php?f=3&t=43075

This thread may be helpful

 

[amiller]

Hey everyone.

I'm new to this site and I just ordered an Egnater M4 and a Randall RT2/50. I'm curious if anyone is familiar with using a TC Electroic G system to controll this setup via midi? ie: switching the M4 Modular channels and from the 6L6's and EL34's in the RT2/50.

Thanks
Drew

Where did you order your M4 from? I've been wanting to check on out.

 

[Drew Wright]

Hey thanks for the response fellas I appreciate it.

I ordered it straight from the factory.