
Ventura
Well-known member
Alright...
Couple questions. So of the 3 loops, 2 are serial, 1 is parallel.
In order to run the parallel, I have to rely on the effect's ON/OFF toggle to mesh it into the signal mix (that along with the mix/volume knob on the back of the Hagen), correct?
As for the switchable serial loop, this is what the toggle is for on the front of the amp, yes? And in order to have levels consistent, is this line level in/line level out on, say, an Eventide stomp? Or is this line level in/amp level out? I'm having a time trying to match levels with this particular loop.
And the last is the straight up serial loop. I'm imagining this is same as the parallel - you need to employ the ON/OFF of the effect itself to get it into the chain, yes?
Thanks Folks!
Mo
Couple questions. So of the 3 loops, 2 are serial, 1 is parallel.
In order to run the parallel, I have to rely on the effect's ON/OFF toggle to mesh it into the signal mix (that along with the mix/volume knob on the back of the Hagen), correct?
As for the switchable serial loop, this is what the toggle is for on the front of the amp, yes? And in order to have levels consistent, is this line level in/line level out on, say, an Eventide stomp? Or is this line level in/amp level out? I'm having a time trying to match levels with this particular loop.
And the last is the straight up serial loop. I'm imagining this is same as the parallel - you need to employ the ON/OFF of the effect itself to get it into the chain, yes?
Thanks Folks!
Mo