New Pedal Board Project

[JerEvil]

Well, the 2 pack of Gorm boards showed up. I had no idea they were preassembled.

Looks like it all fits well and still a little room.

Going to get paint, rubber feet, a board for the back to raise the angle. Should I add a strip to the middle on the bottom for extra support?

I'll post pics as it goes.

 

[NaturalBornBoy]

Is that how you're gonna lay the pedals out?

I'm assuming your signal chain is gonna be like this,

guitar - tuner - wah - amp input

fx send - G3 - fx return

sans the wireless cos' I don't use one so I don't know where that goes.

Maybe you'd wanna have the tuner and the wah next to each other to cut down on unnecessary cable length?

 

[JerEvil]

Is that how you're gonna lay the pedals out?

I'm assuming your signal chain is gonna be like this,

guitar - tuner - wah - amp input

fx send - G3 - fx return

sans the wireless cos' I don't use one so I don't know where that goes.

Maybe you'd wanna have the tuner and the wah next to each other to cut down on unnecessary cable length?

The signal chain will be:
1. Boss TU-2 "Input" to Line 6 Relay "Tuner" input.
2. Line 6 G50 "Output" to EHX Wah "Input", EHX Wah "output" to Splawn "Input".
3. Line 6 receiver to guitar input
4. Splawn "Send" to Zoom G3 input
5. Zoom G3 "output" to SPlawn "Return"

There will still be a bit of cable length from the wireless to the wah but I'm not too concerned with it.