Whenever you power anything, you always want to know the following: # of volts needed, whether its AC or DC, and the current (amps which is usually listed as milliamps(ma)) and if its center negative or positive)
Peterson strobo, xotic rc, ews little brute drive, and arion sch-1, and both hardwire pedals can all run using the standard power cables that come with the pedal power 2+. This is for center negative pedals.
The analogman compressor, assuming it can be powered with just a battery can be used with an adapter Voodoo labs sells. Its a battery cable that goes the the unit. Otherwise, power it the same way you are the xotic, arion and ews pedals.
The micro pog says it must be used with "9.6VDC/200mA AC adapter" Plug it into either jack 5 OR 6 with the dip switch set to normal( it should be already) on the PP2+ and it will power that.
The g50 should be used on either jack 5 or 6 (which ever one you dont use for the pog) and set the dip switch AWAY!! from "normal"http://www.voodoolab.com/forum/viewtopic.php?f=7&t=2233
So for the Peterson, Analogman, Xotic, EWS, Arion, and hardwire pedals you have listed, use outputs 1-4, 7, and 8 on them. Which ones you choose does not matter. You will be one outlet short though. (read on for more info)
The EHX micro pog use either 5 or 6 with the dip switch set to normal, and the g50 use either 5 or 6 with the dip switch set AWAY!! from normal.
Unless you combine power cords for 2 pedals ( I am not familiar with this but it can be done and I have seen it done with Pedal power units before) you will need 2 PP2+'s to do what you want. You need 7 "standard" supplies, 2 special ones configured how I described above for the EHX and the G50, and you can plug the musicom into the extra ac outlet on the back.
If you can plug the Musicom into the same power source the PP is plugged into, you can use the EHX power supply that comes with the Micro pog to plug the micro pog into the ac jack on the back of the PP2+, and then use the jack that would be normally plugged into ( make sure you have the DIP set to normal for any pedal except the G50!!) to power one of the other pedals that have the standard power requirements.
