Setup question: W/D with RJM effects gizmo

[The Hoff]

I am considering a few different possible setups. One possibility I am considering is running my Surreal AKA running wet/dry. I know how to set this up:
Surreal speaker out #1 > Dry cab
Surreal speaker out #2 > Suhr linebox out > effects > 44 mag > wet cab

The thing is, I want to incorporate this into a switching system (using a RJM effects gizmo). I'll have pedals in front of the amp (through the RJM) as well as pedals/rack effects in the loop, both switching through the RJM.

I'm sure this is possible, can someone explain how though. Thanks in advance!

 

[6CA7]

Speaker out #1 is seeing a load via the cab/speaker so #2 needs a load of some sort as well. (Hotplate, Palmer PDI-03, Powerbrake and there are other unit's I can't think of off the top of my head).

From Suhr's page:
The ISO Line Out box is NOT a load box. In other words, the amplifier MUST have a speaker connected at all times. The ISO Line Out box is not a speaker cabinet emulator.

 

[The Hoff]

Speaker out #1 is seeing a load via the cab/speaker so #2 needs a load of some sort as well. (Hotplate, Palmer PDI-03, Powerbrake and there are other unit's I can't think of off the top of my head).

From Suhr's page:
The ISO Line Out box is NOT a load box. In other words, the amplifier MUST have a speaker connected at all times. The ISO Line Out box is not a speaker cabinet emulator.

Ohh, sorry-must not have explained well enough. I'm planning on having two separate cabs. One will be 100% dry the other wet. So yeah, they'll both have a load.

 

[PrestoDone]

Hey Hoff....sorry to get off topic but by any chance do you know if i can use the amp gizmo to switch between 2 amps and their channels? I'm thinking about picking one up but im not sure if it will do it. I know the more expensive rjm rack unit does. Anywho thanks in advance

 

[Reiep]

Speaker out #1 is seeing a load via the cab/speaker so #2 needs a load of some sort as well. (Hotplate, Palmer PDI-03, Powerbrake and there are other unit's I can't think of off the top of my head).

From Suhr's page:
The ISO Line Out box is NOT a load box. In other words, the amplifier MUST have a speaker connected at all times. The ISO Line Out box is not a speaker cabinet emulator.

Ohh, sorry-must not have explained well enough. I'm planning on having two separate cabs. One will be 100% dry the other wet. So yeah, they'll both have a load.

According to you first post you would need 3 cabs : 1 for each speaker out + 1 for the 44 mag so that would make 2 dry 1 wet.

But you can do something way more simple : Speaker out #1 -> ISO Line where :
- Speaker thru -> dry cab
- Line Out -> effects -> 44 mag -> web cab

About the RJM, it'll be after the Line out and before the 44 mag. I'd recommand, when you don't use effects, to have a "kill dry" preset like an empty loop, so that you don't get phase issue. The effects must be run with kill dry/100% wet too.

I hope it helps.