show your pedalboard

[NaturalBornBoy]

A bit late to the party but here's mine anyhoo.

 

[SBlue]

Wow!!! I could never get tired of checking out pedalboards!
Some amazing stuff here!!!!

 

[petejt]

Here's my effects pedalboard. I took a few pedals off it, which are sitting on top of a combo amp now.

 

[IndyWS6]

Here's my effects pedalboard. I took a few pedals off it, which are sitting on top of a combo amp now.

My OCD wants to cover that board with a blanket to hide the cabling

My perv side wants to cover your previous avatar like a blanket

Just messin' with you

 

[petejt]

Here's my effects pedalboard. I took a few pedals off it, which are sitting on top of a combo amp now.

My OCD wants to cover that board with a blanket to hide the cabling

My perv side wants to cover your previous avatar like a blanket

Just messin' with you

Bahahaha!!


You don't want to see the whole room then!

 

[Fragglerick]

All of this going into either a Splawn Quickrod or Nitro. (depending on my mood)

 

[gtrwun]

Just a basic layout before wiring.

 

[RG955TT]

My OCD want to straighten out all the crooked pedals on some of these boards ha ha. That would drive me nuts looking at all those cockeyed pedals.

 

[gweb6969]

Sorry I don't post much here...but I love pedals! This is my standard cover band setup. It does the job.

 

[TheLong]

Here's an old bad pic of the board. Live, I run it into a Twin & Orange RV50. Original band, so I'm chancing my own tones, which is tricky cause I'm never happy.

 

[Bronco]

This was a while back...

 

[lester]

for single and dual amps(switchable buffer and splitter underneath) -

going into clean amp(Mobius looped) -

Axe board -

Got on a kick for a minute putting these together. But honestly end up using a blank Pedaltrain JR the most, just throwing a boost or an overdrive of some sort on it with a tuner and amp switcher. Sometimes maybe a chorus for some cleans.

 

[jc986]

Here's mine:

Nothing crazy, but it's all I need.

 

[tom_h]

Waiting on the new RJM Mastermind PBC, then I'll be building my "permanent" board. After living in the rack world for 15+ years, I can't do without the MIDI switching… I'd be stepping on pedals all night instead of actually performing. My music has a lot of rapid fx and tone changes.

Just got home from CA after doing some west coast gigs and NAMM. Most likely the last gigs I'll be playing with my old rack setup. Here's the temporary board I just built tonight. (Shitty iPhone pic, sorry about that!)

 

[Adambomb]

Finally got my board all wired up with the Disaster Area DPC-5 looper w/midi that controls taps in sync with both Strymons, allows me to run the Mobius in front of amp and in effects loop, and switches my Friedman amp Ch's, Never have been very thrilled with the HOF verb so that's gotta go. Everything's really quiet, and the z-mode buffer in the DPC-5 is the best buffer I've heard.

 

[eco70777]

I love your setup man!!!

 

[webrthomson]

Baby board for grab and go:

Bigger board is still work in progress:

 

[sixstringking713]

I love your setup man!!!

Thanks! Easier on my back than my big rig haha

 

[Brandon Breeze]

K.I.S.S.

 

[datriani]

I actually got this done a few months back. I had Dave build me this one off board to use with my Friedman BE100 half stack. I have had several very custom boards before but I think this may be the best sounding one.

All Strymon gear with a Klon KTR Overdrive and a Suhr Riot Reloaded Distortion. Wah is a CAE Bradshaw. Wired to run 4 cable with the time based fx in the loop and and the wah, Riot & KTR in front.

Sounds amazing. Board is a powder coated FIX Pedalboard.

Nice board. How you liking the Fix board? I've been on the market to replace my trailertrash and pedaltrain boards and this looks like exactly what I had in mind. Very glad you posted and stumbled across your post. Were you considering any other boards before picking up the Fix?