Speaker Cab Mods: Anyone Do This?

  • Thread starter Thread starter dfrattaroli
  • Start date Start date
dfrattaroli

dfrattaroli

New member
Some of you probably know that I've been trying to sell my Uberkab since Jesus was a baby. The reason for the sale is that I have a Mark V:25 coming and want an 8 ohm cab for it. The Uber is 16.

I've considered selling off the speakers and buying 4 8 ohm speakers but I'm not sure I want to go to the trouble of boxing and shipping speakers. So I'm thinking I may add a 2nd jack to the rear panel and wire the speakers in pairs and have 2 separate 8 ohm loads in one box. I could split them up left and right. In theory, I'd have a stereo cab but I'd never use it that way. I'd be able to connect them both to the Mark in the 4 ohm jacks and have the impedance matched. Thoughts?

Maybe it'd just be easier to get a Weber Z-matcher.

PS

I know the 16 ohm cab is a safe mismatch in the 8 ohm output. I've done that with the Mark IV I had. But I'm afraid that with the V:25s smaller tubes/transformer that I'll suffer some loss of punch. I'll try it before I do anything but the amp is still 5 weeks away as it's a custom order.

Thanks.
Dave
 
You can just rewire the cab to 4 ohms. No need for a separate jack.
 
Just rewire the entire cab to 4 ohms. One jack, no extra mods, simple :
 

Attachments

  • 4-Speaker_Parallel_Wiring_D_zpsa074c0b7.gif
    4-Speaker_Parallel_Wiring_D_zpsa074c0b7.gif
    24.9 KB · Views: 1,098
I re-wired the cab to 4 ohms last night. I was surprised to see how thick a 10 guage line was. I was also surprised that the solder joints weren't quite as good as I'd expect. I opted to use 12 guage Sound Runner cable instead since it was a little easier to work with. I didn't want to toast anything in the process.

I get a reading of 3.6 ohms now as opposed to 13.6 before. That's at the jack. It changes a little if I measure from the speaker cable. I also got slightly different readings by plugging in different speaker cables. Now, to wait 5 weeks to get the V:25.
 
dfrattaroli":2kht7jbs said:
I get a reading of 3.6 ohms now as opposed to 13.6 before. That's at the jack. It changes a little if I measure from the speaker cable. I also got slightly different readings by plugging in different speaker cables.
Click to expand...

That is correct and normal. You did it right.
 
You must log in or register to reply here.
Back
Top