Strymon Mobius Pre-Post Cable Routing

[Vader]

I have just replaced all of my single modulation stomp boxes with the Strymon Mobius. I am wanting to know how I would go about routing my cables so that I can use the phasers/Filters/Vibes pre dirt and use all remaining Mobius effects in the effects loop. I use my amp distortion mainly but do have dirt pedals in my chain.

I do not have any fancy true bypass loopers, and my signal chain is as follows (With the Mobius in the loop only)-

Preamp: Guitar-> Polytune->535Q->Deep Six Compressor->ARC Klone V2->Pharaoh Fuzz->ISP Decimator->Amp Input

Effects Loop: Effects Loop Send->Strymon Mobius->Diamond Memory Lane JR.->Strymon Blue Sky->Ditto Looper X2->Effects Loop Return.

 

[thiswaythatway]

Left in and out for your amp input. Right in/out for your effects loop but set the switch on the back of the Mobius for pre/post and you also have to set each effect in the menu for pre or post.

I tried all that but still liked everything into my amps input. I did go back to individual pedals but still liked the Mobius.

 

[Vader]

Thanks. So based on that I should be able to do this?

Preamp:

Guitar ->Polytune->535Q->Deep Six Compressor->Left in Mobius->Left Out Mobius->ARC Klone V2->Pharaoh Fuzz->ISP Decimator->Amp Input

Effects Loop:

Effects loop send ->Right in Mobius->Right Out Mobius->Memory Lane JR.->Strymon Blue Sky->Ditto Looper X2->Effects Loop Return