Tube placement order for Soldano Hot Rod 50+?

  • Thread starter Thread starter ConcreteVampire
  • Start date Start date
ConcreteVampire

ConcreteVampire

Active member
Probably, V1, closest to input jack... which ones the PI?
 
yes I believe that v1 is next to input pi is farthest right
 
Yes, that is correct. Far left when viewed from the front is V1, far right is phase inverter.

Bill Sundt at Soldano also told me not to use a Sovtek 12ax7lps or 12ax7lp in the third position from the left when facing the amp. Apparently they sometimes won't hold up in that spot.
 
sswanson":1dt6mrf9 said:
Yes, that is correct. Far left when viewed from the front is V1, far right is phase inverter.

Bill Sundt at Soldano also told me not to use a Sovtek 12ax7lps or 12ax7lp in the third position from the left when facing the amp. Apparently they sometimes won't hold up in that spot.
Click to expand...

I'm tryin a GT "High gain Marshall Kit" in, 1/2&PI, EH in 3&4.... (Hope no-one starts a GT Tirade... :gethim: ) it was practically given to me... :thumbsup:
 
You must log in or register to reply here.
Back
Top