You can only have 1 channel of 1 amp...

  • Thread starter Thread starter Ventura
  • Start date Start date
My 1982 Marshall JCM800 combo 1x12 with EL34s and a 1x12 cab underneath turned up to about 6. It'll peel the paint off the walls and you won't stop playing it for two hours.It's that good!
 
You can only have 1 channel of 1 amp...no, you can't make me :lol: :LOL:

blue channel 101b..... till the next one.
 
No axefx trolls yet? :lol: :LOL:

I'm honestly a bigger fan of pedals in a good platform, but since that's not allowed, I'll take my chances with the Cameron jcm800. :rock:
 
Egnater modified JCM 800 with the active tube buffered loop...it's called the Megadrive Preamp and was printed in GP back in the 90s , and I'd add the low end density control.
 
Peters FSM. :) It's very articulate and handles mid gain up through high gain well. Roll the volume knob back and the bottom end rounds out, mid gets chunky, top stays defined. Love it. :thumbsup:
 
Fortin modded Marshall JMP Cali++ with all the condiments.. 1 channel that will go from near-plexi that rolls off well to face melting ;)
 
For those of you that know me, it's probably pretty obvious...
 
There is no way I could choose just one. I would quit playing or kill myself most likely.
 
Bogner Ecstasy 101B
bognerbig.JPG
 
Either of 2, Carol Ann channel 2 of OD3 amp, (clean and high gain with just the volume knob on the guitar) cause he uses so few gain stages to make a lot of gain. Or the BE channel of BE100 would work for me as well.
 
Back
Top