Hi,
I have an Egnator Rebel 30, with a matching 1x12 extension cab.
Recently, the amp stopped working with the extension cab plugged in.
( yes I set the impedence switch to 8 ohms with the ext cab)
It does not cut out completley, I can still hear a very weak (kind of noisy) signal.
When I disconnect the extension cab ( and set impedence back to 16 ohms), the amp
performs normally - full power, volume, and clean.
Also - when I disconnect the internal speaker, and plug into the extension cabinet, the amp
is fine - IE the extension cabinet is OK.
Has anyone else experienced this ? Any ideas on what could be wrong ?
Thanks in advance
I have an Egnator Rebel 30, with a matching 1x12 extension cab.
Recently, the amp stopped working with the extension cab plugged in.
( yes I set the impedence switch to 8 ohms with the ext cab)
It does not cut out completley, I can still hear a very weak (kind of noisy) signal.
When I disconnect the extension cab ( and set impedence back to 16 ohms), the amp
performs normally - full power, volume, and clean.
Also - when I disconnect the internal speaker, and plug into the extension cabinet, the amp
is fine - IE the extension cabinet is OK.
Has anyone else experienced this ? Any ideas on what could be wrong ?
Thanks in advance