smartskaft2
New member
I just started using the Torpedo Captor X and like it very much. However, I really want to be able to "shut off" the signal path to my cabinet easily. Out of the box, you have to disconnect the speaker cable from the Captor's cab output.
I am guessing that the Captor's cab output connector has a switch, for routing the input signal to the load box circuit.
Is it dangerous for my amp or the Captor if I leave a speaker cable in the Captor's cab output, and placing a HW switch between the Captor and my cabinet?
Will the Captor X handle any voltage spikes when closing/opening the switch? Will it break? Will the amp take the fall?
For home use, it really should have a switch for convenient switching between attenuation or headphone use.
I am guessing that the Captor's cab output connector has a switch, for routing the input signal to the load box circuit.
Is it dangerous for my amp or the Captor if I leave a speaker cable in the Captor's cab output, and placing a HW switch between the Captor and my cabinet?
Will the Captor X handle any voltage spikes when closing/opening the switch? Will it break? Will the amp take the fall?
For home use, it really should have a switch for convenient switching between attenuation or headphone use.