D
doctorunderhill
New member
i believe when setting/adjusting bias it is necessary to have a proper speaker load to protect the transformers- just like in any normal powered on operation.
Yes. You always need to have a load present.i believe when setting/adjusting bias it is necessary to have a proper speaker load to protect the transformers- just like in any normal powered on operation.
Just because I feel like being “that guy”, if all the knobs are on zero and you aren’t putting a signal into the amp, it’ll probably be fine without a load.
I don’t really recommend it though lol
I like to live dangerously lolI would never recommend that. Even in OTC
Based on the OP, I was not going to go there.
I like to live dangerously lol
I treat tube amps like tires, I have fun doing burnouts and then replace them
Good to know you have so much disposable income at your age.
I mean if you have a load in the room, plug it in for sure.
I’d never recommend anyone to drive without a seatbelt either, but we’ve probably all done it a few times