jswevers
New member
Dear all,
My VH4 is a bit more than 1 years old. Yesterday evening I saw that when I switched on the amp all lights were one and that it switched
only to a normal setting when only the right lights were one according to the programmed setting, after I pushed one of the buttons of the Columbus that controls the VH4. I did not notice any problems until a bit later when the amp did not react anymore to Columbus. I check the midi wire but that it was connected correctly at both sides. Therefore I switched of the amp (according to the instructions ;-}) and a bit later I switched it on again and from then on it worked perfectly.
Is this just a one-time problem of can I expect more to come?
Kind regards,
Jan
My VH4 is a bit more than 1 years old. Yesterday evening I saw that when I switched on the amp all lights were one and that it switched
only to a normal setting when only the right lights were one according to the programmed setting, after I pushed one of the buttons of the Columbus that controls the VH4. I did not notice any problems until a bit later when the amp did not react anymore to Columbus. I check the midi wire but that it was connected correctly at both sides. Therefore I switched of the amp (according to the instructions ;-}) and a bit later I switched it on again and from then on it worked perfectly.
Is this just a one-time problem of can I expect more to come?
Kind regards,
Jan
