A
AURORA4DTH
New member
I am looking Looking for an Ampeg System Selector. i have MANY heads I need to connect at one time. This seems to be the only reasonable option.
The selector has two inputs for tube head. All other 6 are not.
I only ever use one head at a time in the studio so my amps dont have to see a load all the time. Can i use that ampeg switcher all 8 inputs with tube heads if i am only using one cab at a time. No other heads turned on other than the one I am using. Also i always use the same cab so whatever head that i would be using would automatically be hooked up to the cab.
For example.
All 8 inputs on the selector would be used from the tube amp heads but only one output would be used on the selector. So the cab selector just stays in position one while i switch between heads, never leaving any head in on mode if it are not being used. So will i run any risk in damaging my tube heads using it this way.
As long as one of the non tube inputs has a load on the other end when I turn the head on and select it i am thinking it should be fine.
Thoughts??
The selector has two inputs for tube head. All other 6 are not.
I only ever use one head at a time in the studio so my amps dont have to see a load all the time. Can i use that ampeg switcher all 8 inputs with tube heads if i am only using one cab at a time. No other heads turned on other than the one I am using. Also i always use the same cab so whatever head that i would be using would automatically be hooked up to the cab.
For example.
All 8 inputs on the selector would be used from the tube amp heads but only one output would be used on the selector. So the cab selector just stays in position one while i switch between heads, never leaving any head in on mode if it are not being used. So will i run any risk in damaging my tube heads using it this way.
As long as one of the non tube inputs has a load on the other end when I turn the head on and select it i am thinking it should be fine.
Thoughts??