McLeanAB
Active member
Hey all,
Wiring up some newly acquired speakers in a 4x12 and as I was sliding on the connector to the terminal, it bent a little and popped out the little wire connected directly to the speaker cone... I carefully re-inserted it into the hole that existed, but there's no sound...
Did I kill my speaker? Is this an easy repair?
Any and all thoughts... ugh... it's not supposed to be a 3x12...
Wiring up some newly acquired speakers in a 4x12 and as I was sliding on the connector to the terminal, it bent a little and popped out the little wire connected directly to the speaker cone... I carefully re-inserted it into the hole that existed, but there's no sound...
Did I kill my speaker? Is this an easy repair?
Any and all thoughts... ugh... it's not supposed to be a 3x12...