cragginshred77
Well-known member
I have the Hybrid and up until this point all my previous amps have one footswitch jack. I use the Line 6 HX effects for pos/pre effects and to change amp channles. I have tried every variation of TRS, TS cables, as well as Tip, Ring T n R, and None in th eprograming section of the hX and no luck. Tried NO knobs pulled and primarily cable running from Pedal out to Amp 'Channel' jack on rear (of the 4 options) -No luck.
I do typically run the presence knob pulled to activate Loop and I like the ch 1 Gain or vol knob pulled for gain depending on the room.
**All I need to do is change amp channels, no othe rboost features needed.
Any help I appreciate it as no manual exists........... But even if one did it would not tell me how to use the HX, I just don't get the 4 jacks on the rear where the Channel jack goes. How does the 'shared ground' work there too?
There is a video a guy on the Wizard FB page shared but he is using a Fractal FX8 and uses to cables with a Y to utilize boost functions
I do typically run the presence knob pulled to activate Loop and I like the ch 1 Gain or vol knob pulled for gain depending on the room.
**All I need to do is change amp channels, no othe rboost features needed.
Any help I appreciate it as no manual exists........... But even if one did it would not tell me how to use the HX, I just don't get the 4 jacks on the rear where the Channel jack goes. How does the 'shared ground' work there too?
There is a video a guy on the Wizard FB page shared but he is using a Fractal FX8 and uses to cables with a Y to utilize boost functions