EGNATER DUAL MODULE OUTPOUT LEVEL PROBLEM ?

  • Thread starter Thread starter luke69
  • Start date Start date
luke69

luke69

New member
i've noticed since a few days that i've a lot of difference of outpout level between all my modules on my M4 V2
the modules are Bassman , T/D , VOX , SL2

on my T/D the ch A ch A gain is at one o'clock and the master at MAX!
in the same time on my bassman module ch A gain is at one o'clock the master at MAX but there is a big outpout level difference the T:D IS HIGHTER

and my VOX with ch A gain at 11o'clock have a master at 2o'clock and is outpout level is more high than the other modules

i've trying that without bright and bass boost engaged

i don't know how old are theses modules i didn't buy them brand new
did you think ti need to replace tubes and maybe the 2 tubes of the rack unit ?
and if i've to replace them what is the best choice factory sovtek or others ? i've read a lot of things about that and it's not easy to choose
i like cleans cruch and moderate highgain sounds as you can see for my modules choice

many thanks :)
 
Nope, that is not a problem. That's normal.

The solution is to set all of your module masters/levels based around the T/D & Vox ch A so that they are set at the level you want.

Personally, I never liked the T/D or V/X Ch A gain any lower than 10 o'clock, so if your individual module gains are set low, that's going to factor into the overall volume, too.
 
THANKS

my setting are more high than 10 o'clock

VOX with ch A gain at 11o'clock
T/D the ch A ch A gain is at one o'clock

i'll try your solution ASAP
:)
 
You must log in or register to reply here.
Back
Top