Bob Savage
Well-known member
Hey peeps,
Anybody have an EPI LP that would like to trade a stock (has to be original) truss cover for one of these?
Long story short: I already have a design but it seems the hole center to centers aren't spot on.
Long story - a customer send me her truss cover, I made a template from the cover and while the cover I sent her back (along with the original cover, she wanted to keep it) and while it fits, the bottom screws had to be put in at a slight angle because the spacing between the one-top screw and the two bottom ones wasn't spot on. My template looks accurate to these that I made, so I'm looking for someone who will send me theirs to keep, so I have it on hand, in exchange for one of these.
I suspect the screw holes on the cover vs. what's drilled are a little off because I noticed the holes on her cover were out of round, but regardless, I like to have an original on-hand so I'm looking for someone to trade. I'll send you yours once I adjust the hole spacing so it's spot on, and cut more of these. Turnaround would be in the days, not weeks.
Anybody have an EPI LP that would like to trade a stock (has to be original) truss cover for one of these?
Long story short: I already have a design but it seems the hole center to centers aren't spot on.
Long story - a customer send me her truss cover, I made a template from the cover and while the cover I sent her back (along with the original cover, she wanted to keep it) and while it fits, the bottom screws had to be put in at a slight angle because the spacing between the one-top screw and the two bottom ones wasn't spot on. My template looks accurate to these that I made, so I'm looking for someone who will send me theirs to keep, so I have it on hand, in exchange for one of these.
I suspect the screw holes on the cover vs. what's drilled are a little off because I noticed the holes on her cover were out of round, but regardless, I like to have an original on-hand so I'm looking for someone to trade. I'll send you yours once I adjust the hole spacing so it's spot on, and cut more of these. Turnaround would be in the days, not weeks.
