EVH-tribute

[guitarnate2000]

Check this out guys. some cat in the Netherlands just commissioned me to print 30 of these and airbrush them with the famous red white and black stripes..

This is the prototype

I have to clean up the code a bit and figure out why the "I" broke off 99.4% into the 20 hour print but so far so good.. also after it is primed and painted there will be no visible printing lines at all. it will be smooth and glossed

So far so good!!

 

[ccn]

Dang , that's awesome .

Thanks

 

[guitarnate2000]

If any of you want one, message me... turn around time with paint is about a week. it take 21 hours to print each one at this size. I can scale them smaller but not much bigger

 

[guitarnate2000]

Dang , that's awesome .

Thanks

thanks bro!

 

[JackBootedThug]

Sweet

 

[John4021]

What printer are you using.
At first I thought I might have been a Lazer cut out until I seen the detail.

Well done

 

[guitarnate2000]

What printer are you using.
At first I thought I might have been a Lazer cut out until I seen the detail.

Well done

I have two Raise3D E2CF printers. I am already printing the second revision. the first one usually shows some signs of a 3d printer and then I lower the layer height. once I prime and airbrush these, you'll never know it was done on a filament base printer. I can even print these in Carbon Fiber. Why anybody would want one printed from that, I would not have a clue, but I can, nonetheless.

 

[John4021]

No flash(parts come out with no trimming) is what sets this apart from plastic injection molding.
Give it another 10 years and I bet the cost/speed will be, if company doesn't own one, your in the dark ages.

Did you write the program?
And the "longhorn skull looks cool. You did that as well?

 

[guitarnate2000]

No flash(parts come out with no trimming) is what sets this apart from plastic injection molding.
Give it another 10 years and I bet the cost/speed will be, if company doesn't own one, your in the dark ages.

Did you write the program?
And the "longhorn skull looks cool. You did that as well?

I took a few designs and made a best of

Yep longhorn is printed too and the textured and painted

 

[guitarnate2000]

added first few coats of primer.

 

[artiewylde]

Check this out guys. some cat in the Netherlands just commissioned me to print 30 of these and airbrush them with the famous red white and black stripes..

This is the prototype

I have to clean up the code a bit and figure out why the "I" broke off 99.4% into the 20 hour print but so far so good.. also after it is primed and painted there will be no visible printing lines at all. it will be smooth and glossed

So far so good!!

View attachment 225028View attachment 225031

Cool

 

[scottosan]

Are you going the paint the stock grill red and do black and white stripes!

 

[Speeddemon]

Nice! It wouldn't be for the guitarplayer of Eruption, would it? They're a cool tribute that we did some shows with.
Too bad their bassplayer -while a solid dude- doesn't do the high MA backing vox...

 

[JackBootedThug]

Awesome stuff….