GCX help needed

[mboogman]

I posted this in the main section, but suggested to also ask here.

My GCX had been internally wired for series operation (which I un-modded) but it also had a grounding buss wire installed on both PCB's. (See pic) I went ahead and removed the wire because I figured it wasn't necessary, since looking at the PCB, it seems as though the in, send, and out are already tied together on one grounding plane. Did I do right, or should I re-install the grounding buss wire?

 

[RACKSYSTEMS]

You have removed the hot of the in and out of the loop. The ground is the long buss along the jack side of the board.

 

[mboogman]

I removed that too. Last night at practice, everything worked perfectly.