Capulin Overdrive":aa146 said:
can somebody explain the best or at least a good way to Slave the Mesa's?
i've been trolling the Metro board and ended up trying it with mine. i just ran the slave out from one to the front input of the other, and it was kindda cool, but would like to not be able to hear the first amp?
The guys on the Metro site are slaving there amps a bit differently then the norm. What I mean is that they are using plexi type amps that have only 2 gain stages and they are sending the signal of one amp into the input of another to increase the gain to 4 gain stages ( which is not the normal way to slave.)
The usual way to slave and amp is to take the direct out of one amp (if the amp has one built in) or the tap of a hotplate device and you send that signal to your effects and then out to a poweramp an speakers cabs.
If you don't want to hear the main amp and you only want to hear the slaved sound, you need to use a load box/ dummy load.(like the thd hotplate set to load, weber mass set to load,Powerbrak..etc etc)
The hookup would be..
Mesa amps speaker out to Hotplate set on load (this makes the main amp silent because there is no speaker hooked up and the hotplate takes the load of the amp)
Then you take the direct out and send that signal to your effects and then to a poweramp or effects return of another amp and out to your speakers.
I hope this helps.
~R~