JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser .
For Sale Headfirst MCII Clone build $1350
Thread starter
Thread starter
bwgintegra
Start date
Start date
Dec 3, 2024
To buy, sell, or trade in this section, you must have at least 50 posts and have two-factor authentication enabled.
bwgintegra
Well-known member
I built this a few years ago, loaded with JJ tubes. Does NOT include headshell, Nik at Ceriatone sells headshells for this chassis.
$1350 Shipped via PP Gift
Last edited: Apr 7, 2025
cardinal
Well-known member
Great looking work!
What does the knob to the left of the speaker jacks do?
Is there a lead channel boost switch?
Thanks!
bwgintegra
Well-known member
Great looking work!
What does the knob to the left of the speaker jacks do?
Is there a lead channel boost switch?
Thanks!
The amp has an tube driven effects loop, the control is the loop return level. I need to put a label on it.
The boost for both channels if tied to one switch, I did this so I could use just one TRS footswitch jack.
bwgintegra
Well-known member
bwgintegra
Well-known member
bwgintegra
Well-known member
Nice build!
An original Wizard MCII goes for 50 watt - 5495.00 USD, fyi BUMP!!
How do these things stack up against the originals?
A circuit is a circuit, but obviously component selection is a big variable.
DanTravis62
Well-known member
bwgintegra
Well-known member
travis bickle
Active member
bwgintegra
Well-known member
yes el34 power tubes. Also, anyone interesed that would like the gain boost for the channels to be indepentantly switch I can add panel swith, LED, and TS jack.
bwgintegra
Well-known member
bwgintegra
Well-known member
bwgintegra
Well-known member
bwgintegra
Well-known member
bwgintegra
Well-known member
mooncobra
Well-known member
bwgintegra
Well-known member
bwgintegra
Well-known member
I’ve built two of these, this is a clip of the first one I built. The second one have the Rev2 board in it