So I just got the Boss Waza TAE today and just a few minutes ago hooked it up with my Wizard MTL and Marshall 2x12. I connected everything first before powering on the TAE, had the speaker cables in the right jacks and the ohm selectors both set to 8ohms (on amp and TAE). I start to play using the attenuation and after about a minute or two I switch on the FX (prob unrelated) and then I start getting some volume drop and crackling. Even after plugging the amp straight to cab I'm now noticing volume dropping then coming back up and crackle and fizz. I noticed a weird burning electronics smell coming from the back of the amp or TAE and turned everything off. Amp in on the TAE smelled a bit weird and the OT area on my Wiz too. Fuses are fine.
Wondering if I hosed my amp (defective TAE) or just need new power tubes? Thanks ahead for any advice.
Wondering if I hosed my amp (defective TAE) or just need new power tubes? Thanks ahead for any advice.