R
rawpowerocks
New member
I was wondering if any of you can help me?
I have been doing some research on Slash's equipment and am havng trouble with one of his rigs.
It is the rig from the Libertad tour which Dave built.
Basically I am trying to work out exactly how everything was connected up.
What I seem to be having trouble understanding is the Axess RX-1 Switcher/router part.
I have attached a picture of a singal path diagram I have found from a guitar magazine.
This shows his signal coming from his rack wah into the RX-1.
All pedals and some racks in the loops of the RX-1.
Some of the effects are feeding the effects loops of the amps and some are infront of the amp.
Then the RX-1 sending outputs to the inputs of all of his amps.
After looking at the RX-1 manual
http://www.scribd.com/doc/7158648/Axess-RX1-v3r2
I can't seem to work out how this would be possible with the connections on the RX-1?
I also have added a picture of his pedal tray and you can see the pedals have stickers on them saying L1, L10 etc. I am guessing that this is to show what loop they are plugged into?
And I also have attached a picture of his Ground Control Pro board that all this is controlled by.
Notice the clean and dirty amps are selected by the pedal so they must be connected to the Rx-1 but he runs 2 dirty amps and 2 clean amps so the Rx-1 needs 2 b sending 2 signals for dirty output and 2 for clean.
Can anybody explain what gets connected to what connection on the RX-1 for me so I can understand it.
It is driving me mad trying to work this out.
It is probably easy and I am just over thinking it?
Any help would be great
I have been doing some research on Slash's equipment and am havng trouble with one of his rigs.
It is the rig from the Libertad tour which Dave built.
Basically I am trying to work out exactly how everything was connected up.
What I seem to be having trouble understanding is the Axess RX-1 Switcher/router part.
I have attached a picture of a singal path diagram I have found from a guitar magazine.
This shows his signal coming from his rack wah into the RX-1.
All pedals and some racks in the loops of the RX-1.
Some of the effects are feeding the effects loops of the amps and some are infront of the amp.
Then the RX-1 sending outputs to the inputs of all of his amps.
After looking at the RX-1 manual
http://www.scribd.com/doc/7158648/Axess-RX1-v3r2
I can't seem to work out how this would be possible with the connections on the RX-1?
I also have added a picture of his pedal tray and you can see the pedals have stickers on them saying L1, L10 etc. I am guessing that this is to show what loop they are plugged into?
And I also have attached a picture of his Ground Control Pro board that all this is controlled by.
Notice the clean and dirty amps are selected by the pedal so they must be connected to the Rx-1 but he runs 2 dirty amps and 2 clean amps so the Rx-1 needs 2 b sending 2 signals for dirty output and 2 for clean.
Can anybody explain what gets connected to what connection on the RX-1 for me so I can understand it.
It is driving me mad trying to work this out.
It is probably easy and I am just over thinking it?
Any help would be great
