Kemper Profiler, Kemper remote and TC electronic G Gystem

Hello,
my question concerns midi messages. For some time I had used the G System to control my Kemper and this worked seamlessly however, I have “bitten the bullet” and purchased a Kemper remote. What I want to do is use the remote to control both the profiler and G System. So far so good but I’m having difficulty with just one parameter. I send a command by the remote which in turn switches to the rig I want in the Kemper and the Kemper sends a midi command to the G System to change the patch. The patch does change but not to the one I’m looking to use. The only bank that changes is the factory pre set whereas I want to change the user patch. I’ve gone into the G System settings and turned off the factory settings to no avail.
So, what am I doing wrong please?
(Just to illustrate, patch 03 3 user bank on the G System it sends midi number 18 however, when I use the remote to send midi number 18 to the G System it switches on factory preset A3 3 instead)
 
Back
Top