J
Joeglow
New member
I recently purchased this pre amp and still haven't gotten it down just yet to where I like it but I'm also trying to figure on how to set up the signal chain.
What I'm using and not in this order is a TC Electronics Spectracomp compressor, a Boos LS-2 Line Selector, an Akai Deep Impact SB-1. I'm using the XLR out of the preamp into our mixing board. My question is should I put the compressor before the pre amp or last in the chain? Also the LS-2 and SB-1 I want to put in the effects loop of the pre amp as well because I use the function on the LS-2 where both my clean signal and the SB-1 are on together but still go through the pre amp. Which is effectively the return and send ports on the Le Bass. Does this sound correct and if not, please give me some guidance. I'm pretty new to the whole idea of connecting to the pre amp this way and just want to make sure I have this correct. Thanks.
What I'm using and not in this order is a TC Electronics Spectracomp compressor, a Boos LS-2 Line Selector, an Akai Deep Impact SB-1. I'm using the XLR out of the preamp into our mixing board. My question is should I put the compressor before the pre amp or last in the chain? Also the LS-2 and SB-1 I want to put in the effects loop of the pre amp as well because I use the function on the LS-2 where both my clean signal and the SB-1 are on together but still go through the pre amp. Which is effectively the return and send ports on the Le Bass. Does this sound correct and if not, please give me some guidance. I'm pretty new to the whole idea of connecting to the pre amp this way and just want to make sure I have this correct. Thanks.