J
thegame
Well-known member
Pre-relic’d. Really gives off that this cab has been gigged vibe
headlessdeadguy
Well-known member
?
R
Racerxrated
Well-known member
Remember, don't over tighten the screws kids.
* velcro-fly *
Well-known member
With the Punk AF wonky "made in England" sticker
LP Freak
Well-known member
Pretty common on these
RaceU4her
Well-known member
That’s the quality I expect for $1400 or whatever these are going for now
glpg80
Well-known member
Are you kidding? It could have no screw in it at all and still crack ?
Peavey 5150’s are NOTORIOUS for the same thing happening to the top vent due to heat
lespaul6
Well-known member
little bit of superglue and put the screw back in.. gently. and dont ever tough it again lol
saxxamafone
Well-known member
I
itsgoodnow
Well-known member
I don't think I have ever seen a single 5150 that didn't have at least one corner missing on that damn vent.
J
JimAnsell
Well-known member
these cracked when i UNscrewed them. they get brittle AF. this has happened to every 1960 with that plate that i've ever had, thats why i said it the way i did. its always irritating for a second when you see it on your cab.
Orvillain
Active member
The one for my Egnater was solid metal, but the actual electronics and the switching jacks were utter junk!!! They eventually broke on me and half the cab would intermittently die; and I'm guessing the ohmage was changing because of it too. I took them out and hardwired a jack in, job done!
My Marshall cab has one of the deep dish thingymajigs....
I fucking HAAAAAATTTTEEEEEEEE these things!
My Marshall cab has one of the deep dish thingymajigs....
I fucking HAAAAAATTTTEEEEEEEE these things!
M
Mikeyboyeee
Well-known member
Just had same happen in a 2015 Jubilee 4x12.
Speeddemon
Well-known member
Yep, my Marshall 1966A and B cabs have these too. Every friggin' time when that inner jack still loosens itself and falls inside the cabinet....
J
JimAnsell
Well-known member
That1Guy
Active member
That's character right there