Mod 100 phantom power

[jmgman69]

So the manual says pins 1&3 and 6&7 on the Mod 100 and for the M4 and Mod 50 it says 1&3 and 3&7 , so I have an RJM mastermind that works on 6&7 so am I ok to run it with the Mod 100?I think I have this right

 

[Flump]

I would assume that it would work.

My mod 50 actually phantom powers my Rocktron All Access, and the All Access uses pins 6 and 7, so I would think you'd have no problem.

Odd that the Mod50 doesn't mention the 7th pin and the all access works.

Edit: The mod 50 manual actually says active on 1&6 and 3&7.

So moral of the story, if my all access requires 6 and 7 and it works yours should too.

 

[Fallout Labs]

I would assume that it would work.

My mod 50 actually phantom powers my Rocktron All Access, and the All Access uses pins 6 and 7, so I would think you'd have no problem.

Odd that the Mod50 doesn't mention the 7th pin and the all access works.

Edit: The mod 50 manual actually says active on 1&6 and 3&7.

So moral of the story, if my all access requires 6 and 7 and it works yours should too.

i'm assuming this means (1+3), (6+7)

 

[Flump]

I would assume that it would work.

My mod 50 actually phantom powers my Rocktron All Access, and the All Access uses pins 6 and 7, so I would think you'd have no problem.

Odd that the Mod50 doesn't mention the 7th pin and the all access works.

Edit: The mod 50 manual actually says active on 1&6 and 3&7.

So moral of the story, if my all access requires 6 and 7 and it works yours should too.

i'm assuming this means (1+3), (6+7)

Bruce or Jeff would have to confirm, but yea I assume 1+3 is a pos-ground pair, and 6+7 is also a pos.-ground pair.

 

[jmgman69]

Thanks guys,it works