
glassjaw7
Well-known member
I want to purchase a couple Weber Legacy 65 watt speakers before the BOGO (buy one, get one half-off sale) ends, but not sure what ohm rating to buy...I'll be using my Mark IV mostly which has the 8 ohm out, and can also run into a 16 ohm cab as a "safe mismatch".
Am I correct in assuming the following?- Two 16 ohm speakers wired in parallel will give me an 8 ohm cab?
Or could I get two 8 ohm speakers and wire them in series for a 16 ohm cab?
The reason I ask is because eventually, I may want to get two more of these speakers for a 412. Are there noticeable tonal differences between series and parallel? What would you do to get the best tone out of a 212 but also be expandable to a 412 setup down the road?
Am I correct in assuming the following?- Two 16 ohm speakers wired in parallel will give me an 8 ohm cab?
Or could I get two 8 ohm speakers and wire them in series for a 16 ohm cab?
The reason I ask is because eventually, I may want to get two more of these speakers for a 412. Are there noticeable tonal differences between series and parallel? What would you do to get the best tone out of a 212 but also be expandable to a 412 setup down the road?
