Ben Waylin
Banned
Well-known member
I had to drill out the two rivets that held in the original power entry module, and then the new power entry module would not fit thru the hole in the chassis.. so I had to use a Dremel® tool to slightly enlarge the hole.Ironic that there's that tiny fleck of metal right on the crimped edge.![]()
What was supposed to be a simple little upgrade was filled with nasty surprises !
What I thought was a pass through Hot Neutral and Ground connector turned out to be a fused voltage selector - allowing the amp to run at either 120V or 100V (Japan ?)
Last edited: