stepansoukup.cz
New member
Hi, I had classic Captor loadbox. It was good that can work without adapter and I can route one signal for two different speaker cabinets in DAW.
But I thought this I can have in Captor X too, but without DAW.
I bought X and after an initial investigation I ran into the following problems:
1) Captor X can't work without adapter, have not option be power supplied by phantom power as a classic Captor? I thought that yes. Now I must carry one another thing (adapter) to live gigs but the sound is amazing..
2) If I route output as "Dual mono" or "Stereo", I thought the output 1 will be one mic and output 2 will be second mic, for example I send to output 1 Marshall 1960 with SM57, and to output 2 i send the same cabinet, or also other cabinet with Royer 121. But If I set mic A and mic B, to both outputs sounds both mics. It will be solution if I set output as stereo? Stereo by manual information is the same signal to both sides if I understood it right.
I hope you understand my questions.
Thank you for your opinions and help.
But I thought this I can have in Captor X too, but without DAW.
I bought X and after an initial investigation I ran into the following problems:
1) Captor X can't work without adapter, have not option be power supplied by phantom power as a classic Captor? I thought that yes. Now I must carry one another thing (adapter) to live gigs but the sound is amazing..
2) If I route output as "Dual mono" or "Stereo", I thought the output 1 will be one mic and output 2 will be second mic, for example I send to output 1 Marshall 1960 with SM57, and to output 2 i send the same cabinet, or also other cabinet with Royer 121. But If I set mic A and mic B, to both outputs sounds both mics. It will be solution if I set output as stereo? Stereo by manual information is the same signal to both sides if I understood it right.
I hope you understand my questions.
Thank you for your opinions and help.
Last edited: