Verifying cab hookup before i kill the amp

[Shreddy Mercury]

I'm pretty sure this is how I ran this amp in the past but just checking:

2 Budda cabs (one 4x12, one 2x12), both have 8 ohm loads. If I plug each cab into the back of the outputs on the amp (not daisy chaining the cabs), I set the switch to 4 ohms?

 

[LP Freak]

I'm pretty sure this is how I ran this amp in the past but just checking:

2 Budda cabs (one 4x12, one 2x12), both have 8 ohm loads. If I plug each cab into the back of the outputs on the amp (not daisy chaining the cabs), I set the switch to 4 ohms?

Correct