Warhead 4x12 wiring questions

[V-Type]

I just got a decent Warhead 4x12 unloaded.
Its the model with the 3 inputs and no crossover.
I like its wiring harness but wonder how the heck do I wire my 4 - 16 ohms speakers in this.
All the red and black wires run from a central circuit board.
Also if my speakers are all 16 ohms and using the stock wiring harness is my imput ohms going too be the same on the jack plate or different as I'm not sure what ohms the stock speakers were in the first place.
I have a set of G12k85 and a set of V30 just waiting too get hooked up.
Need the Right total ohms and wiring though.
Any help Greatly appreciated.

 

[Bloodrock]

I just got a decent Warhead 4x12 unloaded.
Its the model with the 3 inputs and no crossover.
I like its wiring harness but wonder how the heck do I wire my 4 - 16 ohms speakers in this.
All the red and black wires run from a central circuit board.
Also if my speakers are all 16 ohms and using the stock wiring harness is my imput ohms going too be the same on the jack plate or different as I'm not sure what ohms the stock speakers were in the first place.
I have a set of G12k85 and a set of V30 just waiting too get hooked up.
Need the Right total ohms and wiring though.
Any help Greatly appreciated.

Those cabs came wired a couple of different ways if I remember correctly, some were actually 4 ohms so they could be ran at 2ohms in a full stack (not recommended). It was a pretty screwy setup. If I were you, I'd pull the jack plate and replace it with a regular style 16ohm mono/ 2x8ohm stereo style jack plate if yours is one of the oddball ones. Those cabs kick serious ass though.

 

[chunktone]

I would just wire it series parallel with one jack, and be done with it.

 

[V-Type]

Yeah I'm leaning the easier way of buying the pre assembled harness and then following the diagram for series/parallel or whichever for my Marshall JMD:1
I Do Not want 4 ohms rather 8 and 16 as well.

The G12k85's sound nearly identical to the k100's so those and the 2 V30's + Warhead cab should =
Huge cab btw with its casters on. And without my truck it would be hard to move.