What cable do I need to run effects pedals after the Torpedo Cab M?

[Bennu]

So according to the manual it's best to run reverbs/delays etc after the Torpedo Cab M. The trouble is that I'm not sure what cable I need to do this.

Would something like this be suitable or does the end of the cable going into the pedals after the Cab M need to be balanced?

Cheers

 

[Bennu]

I'm also confused as to what cable I need to connect to the input of the Cab M (after the initial drive pedals). The manual online suggests you need a balanced TRS cable but then the physical documentation I got with the device says you should use a TS instrument cable, does this mean that either one is fine?

 

[Dilan - Two notes]

@Bennu

For the input, yes, either a TS or a TRS cable works fine. If the last device before the C.A.B M has unbalanced outputs, use a TS cable. If it has balanced outputs, use a TRS cable.

It is the same for the outputs. However, in doubt use TRS/balanced cables at the output.