SQUAREHEAD
Well-known member
Yep, should work fine brother!?
C
Clp45
Active member
Cheers appreciate you’re help.
E
EVH73
New member
Am in need of the four button foot switch for my wizard MTL - MCII Hybrid. But it doesn't look like Kool Kat is around anymore, or at least his website. Anyone know of someone I may want to check out or know how to get hold of kool cat?
P
Philhouse
Well-known member
I just found a great option for my MCII. Been hunting for years for the ideal footswitch to modify. This one was pretty much ready to go. I wanted a wider layout rather than the squarer box setup with all the switches too close together.
It's an Ashton FSW400. Comes with twin cables to TRS tips for each pair of switches. I just needed 2 x Female TRS to dual male TS 1/4 adapters/splitters to go into the four jacks on the MCII.
Swapped out the 'Channel' yellow led for a purple led because the yellow wasn't working. All switches and lights work now. No seperate power req'd for the lights.
I did some basic cosmetics with tape, posca and a cut vinyl sticker. If I can figure out a way later to do nicer little switch titles with a silk screen or decals perhaps I might strip the case down, spray it all black and and redo it all a bit nicer, but it works and looks good enough for now.
I'm going to source some braided heatshrink cable shield to keep the two cables together neat and tidy as one rather than having two loose cables.
It's an Ashton FSW400. Comes with twin cables to TRS tips for each pair of switches. I just needed 2 x Female TRS to dual male TS 1/4 adapters/splitters to go into the four jacks on the MCII.
Swapped out the 'Channel' yellow led for a purple led because the yellow wasn't working. All switches and lights work now. No seperate power req'd for the lights.
I did some basic cosmetics with tape, posca and a cut vinyl sticker. If I can figure out a way later to do nicer little switch titles with a silk screen or decals perhaps I might strip the case down, spray it all black and and redo it all a bit nicer, but it works and looks good enough for now.
I'm going to source some braided heatshrink cable shield to keep the two cables together neat and tidy as one rather than having two loose cables.