Wiring a sliding rack tray for pedals

[9841507]

Hello, I'm just wondering how people usually organize cables when wiring a sliding rack tray with pedals that go to a switching system, each pedal needs to be individually wired to the rack unit above the tray in this case. Do you typically just run slack the extra length of the sliders range of motion, seems like a lot of excess but I can't see any other way to do it. If anybody has suggestions I'd appreciate it.

Thanks.

 

[9841507]

Thanks, that's basically what I'm doing with a rack gizmo. Do you know where I could buy a snake like what you have, looks like you use a braided wire loom but have some sort of cap on it?

Thanks again.

 

[9841507]

Thanks, should be good. Looking forward to having it all in a beautiful rack rather than 500 pedals and cables running all over the place.