WW Smallbox TRS Footswitch Wiring

[soundbee]

Hi all

I have a WW Smallbox (3 channels) and trying to setup with an amp switcher (RJM PBC/6) and/or Boss FS-7.... came up with these settings. Note the 4th mode is not available via regular footswitch and effectively gives a secondary volume function to Channel 1/Plexi. Perhaps other 3 channel amps offer something similar.

1. Tip latched = Channel 1 (Plexi / clean)
2. Both latched = Channel 2 (BE)
3. Ring latched = Channel 3 with Boost (BE+)
4. Nothing latched = Channel 3 volume w/ Channel 1 Preamp (Plexi)

... now I want to figure out wiring for a regular 2 button switch that (think KoT pedal

• right side = switches channels
• left side = engages boost

possible with a couple of 3dpdt switches?

 

[soundbee]

So ... I think something like this should work (will use the outside lugs for LEDs to a power input). On switches, top row = on, bottom = off, middle = common

 

[CornNutz]

This is the be100 footsiwtch. The LED's are wired in series.

 

[Nisto]

So ... I think something like this should work (will use the outside lugs for LEDs to a power input). On switches, top row = on, bottom = off, middle = common

View attachment 73398

Did you get this working?