ledvedder
Well-known member
scottosan":20pxooyz said:Grab some 2N5400s while you are at it. I prefer these over the MPSA06 although they are very close. On these you’d wire them the exact opposite as the MPSA06, snip leg 3 as well
Done! MPSA06s and 2N5400s ordered.
Now I just have to figure out the easiest way to test these without having to remove and replace them on the board over and over. Nik has explained it, but I'm still confused with his explanation.
"Say you want to experiment.
The easiest way is to hook it up.
Look at the current config - 1 side is grounded for the zeners on the board. Same with the MV, 1 lug is grounded.
The other side of the zeners, goes to the MV lug, thus they're actually across the MV pot.
So you can just wire from board - 0.22uf to the right leg of MV pot, zeners across to the ground lug of the MV pot
This is just to make it easy, without rewiring on the board, which can make it messy."